Start with the failure pattern. A bead that has detached from a surface, a bead that has split through its middle and a bead that carries a torn coating point to different checks. Record the evidence before removing the joint.
Find the failure face
Where the joint has separated naturally, photograph both surfaces. Adhesive failure presents at an interface. Cohesive failure runs through the sealant, while a failed substrate or coating can come away with intact sealant still attached. One site can have more than one failure mode.
Record the occurrence by joint location and timing. Check if defects correlate with one elevation, the wettest area, one installer shift, one paint batch or one lot of sealant.
Compare the installed joint with the design
Check actual width and depth, movement, backing or bond-breaker, joint-side preparation, primer and the interval before weather or loading. For an uncured or bubbly area, document the installation and storage conditions as well as the condition of the pack. Preserve a sample where your project review allows it.
A controlled adhesion evaluation can help compare surface preparations and installed bonds. Agree the method, damage repair and acceptance criteria with the responsible project team before cutting or straining an installed joint.
Prioritise a repair trial
Separate the plausible causes and change one variable at a time on a mock-up. Keep the design intent, sample lot and replacement material recorded. Refer a recurring leak or safety-critical failure to the responsible system designer before selecting a repair.
Common Questions
Should I substitute a stronger material after seeing a split bead?
First compare the split with the joint movement, actual geometry, state of cure and substrate conditions. Use those findings to choose a specific corrective trial.
Related SIDUN Resources
- Review window and door selection
- Check preparation and application
- Window and door applications
- SIDUN 101 selection context
- Send a failure description
References
Discuss Your Requirement
Share your application, materials and destination market. Identify any samples, pack options or documents you need.